TA Triumph-Adler DCC 2520 - Manual (Page 77)

Fax Operation (Various Functions)
3-11
Sending Documents at a Specified Time (Communication Using the Timer)
If you designate in advance the time for a
communication to begin, that communication will be
carried out automatically once the appointed time is
reached. You can designate a communication to be
one that uses the timer during the operation procedure
for each of various types of fax communication
available in this fax such as Broadcast Transmission.
The example in the procedure below is for the
transmission of documents to a single destination
using the timer function.
IMPORTANT: If the time that is shown in the touch panel on the operation panel does not match the
current time, communications that use the timer may not be accomplished as expected. If the
displayed time is not current, be sure to adjust it to match the correct time.
NOTE: Communication using the timer is not available in the Direct Feed Transmission mode.
Each communication that uses the timer can be set to begin at any minute between 00:00 - 23:59.
A maximum of 50 communications (including any combination of communications that use the
timer, Interrupt Transmissions and Standby Transmissions) can be scheduled at one time.
When 2 or more communications that use the timer are scheduled to begin at the same time,
fundamentally each communication will be accomplished in the order that they were registered.
However, even if it has been registered later, any communication that scheduled with a single
location will take priority over a communication to multiple locations.
It is possible to cancel or change the contents of a communication that is waiting for a start time,
(Refer to Managing Information for a Scheduled Communication (Editing a Communication in
Memory) on page 3-18.)
If you want to cancel the procedure part way through, press the Reset key. The touch panel will
return to the initial mode settings.
1 Set the documents you want to transmit in the
Document Processor or on the platen.
NOTE: When the documents are set on the platen, it
is necessary, after each page is scanned, to select
whether or not you want to transmit more pages and
to select the size of each page. (Refer to page 2-8.)
2 Enter the destination fax number.
Press start key to transmit
Dest
Ready for fax transmission.
Basic Application
Duplex Address
Register
TX book
Print Report
Memory
OCT-11
1234_ .
Abbrev.
One touch
destinat.
Delayed TX
Orig. size
setting
Orig image
quality
Exposure
mode
8½×11" Normal Regular
Delete Space Pause Subadd. Next des