TA Triumph-Adler DCC 2520 - Manual (Page 22)

Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)
1-6
Preparations
When using the fax functions of this machine for the first time after purchasing your Fax System,
perform the procedures as explained in Designating the Type of Phone Line Being Used (Line Type
setting) (Inch version only) through Setting the Current Date and Time (Date & Time setting).
NOTE: If your service representative performs these settings during set-up of your Fax System,
there is no further need for you to perform these procedures.
Designating the Type of Phone Line Being Used (Line Type setting) (Inch version only)
Set the type of phone line here to correspond to the type of telephone service that you are using. BE
SURE the type of phone line you select here is correct because, if the setting is incorrect, fax
communication will be impossible.
NOTE: Prior to operation, check the message display to make sure that the touch panel is in the
initial mode for fax operation. (Refer to What is the Initial Mode? on page 1-11.)
If you want to cancel the procedure part way through, press the Reset key. The touch panel will
return to the initial mode screen.
1 Press the System Menu/Counter key. The Default
Setting screen will appear.
2 Press the [FAX Default] key.
3 Make sure that Line Type is highlighted and press the [Change #] key.
4 Press either the [Tone Line (DTMF)] key
or the [Pulse Line (10PPS)] key, as
appropriate.
5 Press the [Close] key. The message display will return to the same screen as was displayed in step
3.
6 If you are finished making settings, press the Reset key to return to the initial mode.
System Menu
Default
Scanner
Default
Copy
Default
FAX
Language
Setting
MP tray
Orig. Size
Register
Management
Document
Default
Printer
Default
Machine
Accounting
Job
Management
BOX
Report
Print
System Menu / Counter
Line Type
Tone line
(DTMF)
Pulse line
(10 PPS)
Default setting screen
Back