TA Triumph-Adler DCC 2520 - Manual (Page 184)

Various Settings and Registration
7-2
Turning Print Out of Each Report ON/OFF (Print Report setting)
Six different reports can be printed out for checking such points as whether a transmission or
reception was accomplished correctly or not. You can also have each of these reports printed out
automatically or turn OFF automatic print out of each report.
Activity Report
Set this report to be printed out upon reaching a predetermined number of communications in order
to check the details of those communications.
Transmission Report
Set this report to be printed out after each transmission to check whether the transmission was
accomplished correctly or not.
NOTE: Select [Output on condition] and then, it is possible to set this report to be printed out only
under certain condition such as a communication error and a Broadcast Transmission.
Reception Report
Set this report to be printed out after each reception to check whether the reception was
accomplished correctly or not.
NOTE: Select [Output on condition] and then, it is possible to set this report to be printed out only
under certain condition such as a communication error, a Polling Reception, an Encryption
Reception and an F-Code Based Confidential Reception.
Delayed Communication Report
Set this report to be printed out after each communication that uses the timer is scheduled to check
the information related to that communication.
Restricted Access Report
Set this report to be printed out whenever Restricted Access is turned ON in order to check the
details, listed by department, of all communications occurring under Restricted Access.
NW-FAX Transmission Report
You can have this report attached to an e-mail message in order to check whether each Network
FAX transmission was accomplished correctly or not.
NOTE: Select [Output on condition] and then, it is possible to set this report to be printed out only
under certain condition such as a communication error and a Broadcast Transmission.
NOTE: If you want to cancel the procedure part way through, press the Reset key. The touch panel
will return to the initial mode settings.