TA Triumph-Adler DCC 2520 - Manual (Page 61)

Fax Operation (Basic Use)
2-25
Dialing the Destination Using Only a 4-Digit Number (Abbreviated Dialing)
Speed-dial keys are available to be registered as either
a one-touch key, a group dial key, a program key or a
chain dial key. Each of these keys is given a 4-digit
number between 0001 and 1000 and this number is
referred to as that key's [abbreviated number]. It is then
possible to dial a destination number by simply
entering the corresponding abbreviated number.
NOTE: Prior to operation, check the message display to make sure that the touch panel is in the
initial mode for fax operation. (Refer to What is the Initial Mode? on page 1-11.)
If you want to cancel the procedure part way through, press the Reset key. The touch panel will
return to the initial mode settings.
1 Set the documents you want to transmit.
2 If you want to change the transmission conditions, such as the resolution and contrast, press the
[TX setting] key.
If you do NOT want to change the current conditions, go directly to step 5.
3 Press the key that corresponds to the desired item and change the information as desired.
To change each transmission condition, refer to pages 2-5 and 2-6.
4 Once you are finished changing
transmission conditions, press the
[Abbrev.] key and then go directly to step
6.
5 Press the [Abbrev.] key.
Enter Destination.
Dest
Ready for fax transmission.
Basic Application
Duplex Address
Register
TX book
Print Report
Memory
OCT-11
Abbrev.
One touch
destinat.
Delayed TX
Orig. size
setting
Orig image
quality
Exposure
mode
8½×11" Normal Light
Save Tx.
original
Enter Destination.
Dest
Ready for fax transmission.
Basic Application
Abbrev. Address
Register
book
Print Report
Memory
OCT-11
TX
setting
ABC .