Hammond SK Pro-73 73-Key Portable Keyboard/Organ - Manual (Page 104)

*#1 SK PRO/SK PRO-73 Owner’s Manual
104
MONO SYNTH - continued
EG DEPTH
Setting Range: -64 ~ ±0 ~ +63
Th is allows you to adjust the amount of the changing Cutoff
Frequency by the Filter EG.
At “0” the Cutoff Frequency does not change. At “-64” or
“+63,” the Cutoff Frequency changes by a wide amount.
DRIVE LEVEL
Setting Range: 0 ~ 127
Th is allows you to adjust the signal level going into the Filter.
“64” is a “clean” signal with no distortion. A higher value adds
distortion.
AMPLITUDE
This Page allows you to adjust the Parameters controlling
loudness.
GENERAL LEVEL
Setting Range: 0 ~ 127
Th is allows you to adjust the overall volume.
VELOCITY DEPTH
Setting Range: 0 ~ 127
Th is allows you to adjust how the volume changes by keyboard
velocity.
At “0” there is no change in velocity. At “127,” the volume is
changed by the maximum amount in proportion to the velocity.
AMPLITUDE EG
SHORTCUT: Press and Hold the [SHIFT ] button and move the
AMPLITUDE ENVELOPE [ATTACK], [DECAY], [SUSTAIN] or
[RELEASE] sliders.
The Amplitude EG is an Envelope Generator which affects
Volume. It works in a manner similar to the Pitch&Filter EG’s.
PITCH & FILTER EG
SHORTCUT: Press and Hold the [SHIFT] button and move the PITCH
& FILTER ENVELOPE [ATTACK], [DECAY], [SUSTAIN] or
[RELEASE] sliders.
Th e EG ( Envelope Generator) allows you to control how the
sound changes over time.
Th
is EG aff ects both the Pitch and the Cutoff Frequency of the
Filter.
Attack Decay Release
Sustain
On Off
ATTACK RATE
Setting Range: 0 ~ 127
Th is allows you to adjust the time for the sound to increase to
its peak value beginning when a key is depressed. A higher value
will result in a slower Attack Rate.
DECAY RATE
Setting Range: 0 ~ 127
Th is allows you to adjust the time from the peak amount to the
Sustain Level (explained below). A higher value will result in a
longer Decay Rate.
SUSTAIN LEVEL
Setting Range: 0 ~ 127
Th is allows you to adjust the main level which will remain until
the key is released. A higher value will result in a higher Sustain
Level.
RELEASE RATE
Setting Range: 0 ~ 127
Th is allows you to adjust the time for the level to fade from the
Sustain Level to zero after the key is released. A higher value will
result in a longer Release time.