Hammond SK Pro-73 73-Key Portable Keyboard/Organ - Manual (Page 126)

*#1 SK PRO/SK PRO-73 Owner’s Manual
126
CUSTOM PIPE
Th is FUNCTION Mode allows you to select or edit the characteristics of the Pipe Voices.
Th e Parameters described on these pages are grouped in macro-settings called Custom PIPES.
Th ese Parameters cannot be Recorded as individual Patch Parameters; however, a Custom Pipe can
be Recorded as part of an ORGAN Patch.
To locate this mode:
[MENU/EXIT] - CUSTOM - PIPE - [ENTER]
SET
CUSTOM SET
Setting Range: F1 ~ F3, U1 ~ U3
Th is allows you to select the Custom Pipe Number to edit.
Th e letter “F” stands for Factory (non-re-writable) and “U” stands for User (re-
writable).
UPPER / LOWER / PEDAL STOP SET
Th is allows you to assign Pipe Voices to the Drawbars and to adjust the Parameters
of each Stop to your preference. Each Parameter is explained in detail starting below.
STOP (Pi)
Th is allows you to assign a Pipe Stop to each of the Drawbars.
NOTE: See page 179 for a list of the available Pipe Stops.
VOLUME (Pi)
Setting Range: -Inf, -92.0 ~ +4.0 [dB]
Th is allows you to adjust the Volume of each Pipe Stop.
FOOTAGE (Pi)
Setting Range: 32, 16, 5 1/3, 8, 4, 2 2/3, 2, 1 3/5, 1 1/3, 1
Th is allows you to adjust the Pitch of each Pipe Stop. Th e pitches are expressed in
Footages.
NOTE: See page 38 for more information about Drawbars and their Footage designations.
TUNE (Pi)
Setting Range: -50 ~ ±0 ~ +50 [cent]
Th is allows you to detune the pitch of the selected Pipe Voice Up or Down by cents
(50 cents = one quarter-step).
TREMULANT (Pi)
Settings: Off , On
Th is allows you to add Tremulant to the Pipe Voices using the [VIBRATO] controls.
TREMULANT
P i p e o r g a n s t y p i c a l l y h a v e o n e o r m o r e
“tremulants” which vary the air pressure to the
pipes periodically, producing a vibrato or tremolo
eff ect.
WHAT ARE “CUSTOM PIPES?”
All of the Parameters described on this page
and on the following page comprise a Custom
Pipe. These Parameters cannot be Recorded as
individual Patch Parameters; however, a Custom
Pipe can be Recorded as part of a Patch.
The SK PRO has 3 diff erent Factory Custom Pipes,
indicated by an “F,” which are permanently written
in memory. You can create and Record up to 3 User
Custom Pipes which will be indicated by a “U.”
To create and Record a Custom Pipe, use the PIPE
FUNCTION Mode to edit the Parameters of one of
the “F” Custom Pipes. After you have made all of
your changes, you can Save them as a “U” Custom
Pipe.