Hammond SK Pro-73 73-Key Portable Keyboard/Organ - Manual (Page 82)

*#1 SK PRO/SK PRO-73 Owner’s Manual
82
GENERAL
SHORTCUT: Press the [UPPER] and [PEDAL] DRAWBAR SELECT buttons simultaneously.
Th is Page allows you to adjust Parameters common to the ORGAN Patches.
LOUDNESS
VOLUME
Setting Range: 0 - 127
Th is allows you to adjust the maximum volume of the selected Patch.
PITCH BEND
RANGE UP
Setting Range: 0 - 12 [semitones]
RANGE DOWN
Setting Range: 0 - 24 [semitones]
Th ese allow you to adjust the number of semitones the pitch of the selected ORGAN
Patch will bend “Up” or“Down” using the [PITCH BEND] wheel.
DRAWBARS
Th is allows you to adjust the Drawbars Parameters for each Part.
UPPER Registration
PEDAL Registration
LOWER Registration
Th is allows you to see the Drawbar Registrations for each Part.
ORGAN - continued
DISABLED PARAMETERS
All of the ORGAN Parameters aff ect the Tone Wheel
Organs; however, some of the ORGAN Parameters
do not affect the Transistor or Pipe Organs - for
example, Leakage Level, Pedal Type and Custom
Tone Wheels. If a particular Parameter does not
affect the selected Organ Type, it will be “greyed
out” or darkened in the display (see the example
below). However, the value of a disabled Parameter
can still be adjusted using the [VALUE] knob.
WHERE THE VOLUME AFFECTS FOR?
The LOUDNESS - VOLUME adjusts the volume
which end of the Multi Eff ects or Overdrive Eff ects,
unlike the Expression. This is used for adjusting
volume of the current Patch.
Expression
“Volume” in the Patch
(LOUDNESS Parameter)
Overdrive, Multi Effects
“Volume” in the
Combination
audio
output