Hammond SK Pro-73 73-Key Portable Keyboard/Organ - Manual (Page 48)

*#1 SK PRO/SK PRO-73 Owner’s Manual
48
MONO SYNTH Patches are explained in detail starting below.
ALLOCATING THE SECTION TO A KEYBOARD
To play the MONO SYNTH on the keyboard,
simply press the [MONO SYNTH] button in the
[ALLOCATE] button group. Th
e LED will light red.
NOTE: If only the MONO SYNTH Section is active (no
other [ALLOCATE] buttons lit), the PLAY Mode will
display only the MONO SYNTH Parameters.
NOTE: If the SPLIT button is “ON” (LED lit), the MONO
SYNTH will play to the right of the SPLIT Point only.
RECALLING A PATCH
For this example, recall MONO SYNTH Patch F048 (“4th Saw Ld”).
MOVE THE CURSOR TO THE MONO SYNTH PATCH NUMBER
SELECT THE PATCH
Use the DIRECTION buttons to move the
cursor to the MONO SYNTH Patch Number.
Use the [VALUE] knob to scroll through the Patch List.
For this example, when you have located Patch F048 (“4th Saw
Ld”), press either the [PLAY] or [ENTER] button to return from
Patch List to PLAY Mode.
NOTE: You can also use the PAGE [  ]/[  ] buttons to scroll through the
Patch List.
OPEN THE PATCH LIST
Th e Patch List allows you to scroll through the Patches quickly to
fi nd the Patch you want.
With the cursor highlighting the Patch Number, press [ENTER]
to open the Patch List. You will see a screen similar to the one
shown at the left.
PLAY Mode (Mono Synth)
PLAY Mode (Mono Synth) PLAY Mode (General)
USING MONO SYNTH PATCHES