Hammond SK Pro-73 73-Key Portable Keyboard/Organ - Manual (Page 155)

155
MIDI
USING A MIDI SOUND MODULE
To control a MIDI Sound Module from the SK PRO using both a single keyboard and Expanded Keyboards,
do the following:
CONNECT THE MIDI MODULE
Connect the MIDI OUT of the SK PRO to the MIDI IN of the
MIDI Sound Module.
LOAD THE “EXZ...”MIDI TEMPLATE (P. 158)
Th is MIDI Template mutes the Keyboard Channels. If you
want also to transmit MIDI data on the Keyboard Channels,
you must turn them “ON” manually. See page 159 “MIDI
Channels” for instructions on how to do this.
SET THE ZONES AND RECORD THE SETTINGS
TO THE COMBINATION.
Please refer to page 78 “COMBINATION-EXTERNAL
ZONES” for instructions on how to set Zones.
BASIC CONNECTIONS
SOUNDING POINT OF THE EXTERNAL ZONES
When keys are depressed, the sounding point of the
External Zones is deeper than that of the ORGAN Section.
MIDI Keyboard
MIDI Pedalboard
MIDI OUT
- MIDI -
OUT MERGE
IN
Optional
IN OUT THRU
- MIDI -
MIDI Sound Module
SIMPLIFIED SETUP MODE
Th e setup mode described below allows you to transmit MIDI
data without using the External Zones.
CONNECT A MIDI MODULE
Connect the MIDI OUT of the SK PRO to the MIDI IN of the
MIDI Sound Module.
LOAD THE MIDI TEMPLATE FOR YOUR SYSTEM
(P. 158).
Select the MIDI Template to Load (Basic, Lower, Lower+Pedal,
etc.) depending upon whether you are using Expanded
Keyboards.
TURN OFF UNUSED MIDI MESSAGES (P. 158).
Turn MIDI messages for controlling Program Change, Drawbar
Registration and NRPN “OFF.” Th
ese messages are not used in
this setup.
MATCH THE MIDI CHANNELS (P. 159).
Match the MIDI Channels between the Keyboard Channels of
the SK PRO and the MIDI Sound Module.
NOTE: Sounding Range and Program Change cannot be changed by
a Combination in this simplifi ed set up.
Load the “EXZ...” MIDI Template.