Hammond SK Pro-73 73-Key Portable Keyboard/Organ - Manual (Page 132)

*#1 SK PRO/SK PRO-73 Owner’s Manual
132
CONTROL
Th is FUNCTION Mode allows you to select the Parameters for the various Controls, including Foot
Switches, Expression Pedals, controls on the Control Panel and the display.
To locate this mode:
[MENU/EXIT] - SYSTEM - CONTROL - [ENTER]
or, Press the [CONTROL] button.
FOOT SWITCH 1/2
Th is Page allows you to select the Function of devices connected to the Foot Switch
[FOOT SWITCH 1/2] jacks.
DEVICE
Th is allows you to select the device to be connected to the [FOOT SWITCH 1] jack.
Foot Switch ...................... Foot Switch.
Leslie Switch .................... Leslie Switch (such as FS-10TL).
NOTE: The FOOT SWITCH 2 jack will not accept a Leslie Switch.
MODE - TIP
Th is allows you to select the function of the “Tip Mode” of a connected Foot Switch.
Off ............................................... No function.
Leslie S/F Alt, Mom, Tri ...... Allows you to switch the Leslie Rotors among “Slow/Fast/Stop.”
Alt .................................. Alternates between “Fast/Slow” or “Fast/Stop” depending on the
position of the [STOP] button.
TRI ................................. Switches to Stop when the foot switch is pressed and held down
for approximately 1 second.
MOM ............................ Switches to Fast while the foot switch is held down. When
released, it switches to either Slow or Stop depending on the
position of the [STOP] button.
Tone Wheel Brake ................ Allows you to bend the pitch, with the amount being determined
by a Parameter setting (P. 135).
Favorite Fwd, Rev ................ Allows you to move Forward or Backward through the Favorites
(P. 27).
Spring Shock .......................... Allows you to produce the eff ect of a Spring Reverb unit being
jostled.
MFX2 Delay Time ................. Allows you to adjust the Delay Time of the Eff ects, at the interval
of pressing the Foot Switch. The delayed sound disappears by
the Foot Switch is held down (P. 115).
Organ U&L Sustain ............. Allows you to add Sustain to the UPPER and LOWER ORGAN
tones (except Pipe) (P. 84).
Pedal To Lower ...................... Allows you to activate PEDAL TO LOWER (P. 55).
Bass 1C - Bass 3C .................. Allows you to trigger the specifi ed note of the PEDAL Part.
ProChord ................................. Allows you to activate the ProChord harmony (P. 92).
NOTE: All of the above functions can be set for either Tip or Ring Mode. However, Ring Mode
will have no eff ect if only one Foot Switch is connected to the FOOT SW jack.
MODE - RING
Th is allows you to select the function of the “Ring Mode” of a connected Foot Switch.
CALIBRATE
Th is allows you to confi gure a Foot Switch to work properly with the SK PRO. To set
this Parameter, move the cursor to this icon and press the [ENTER] button without
pressing the Foot Switch.
WHAT IS “TRS?”
TRS is an acronym for “Tip-Ring-Sleeve,” and refers
to the fact that a connecting plug can have more
than one connector. Using a Stereo Adapter,
more than one Foot Switch can be connected to
the SK PRO, thereby allowing you to control more
than one function using the same Foot Switch.
jack.
Tip
Ring
Sleeve
SPRING SHOCK
“Spring Shock” occurs when the springs in a spring
reverb unit move around and strike the reverb
tank, resulting in a loud “bang.” This has usually
been regarded as a negative effect; however,
some modern and progressive music uses this
as a musical effect. This Parameter allows you
to introduce the effect of a spring reverb being
jostled.
CALIBRATE
Some Foot Switches, such as Hammond, are “+”
or “positive” (make contact when pressed) while
others are “-” or “negative” (break contact when
pressed). The CALIBRATE Parameter allows you
to confi gure a Foot Switch so that it will function
correctly with the SK PRO.
BASS 1C - BASS 3C
Many jazz and blues organists provide a bass line
with the left hand on the Lower Manual and strike
one Pedal note at the onset of each bass note to
give the effect of a plucked string bass (called a
“thump”). The BASS 1C - BASS 3C Parameter allows
you to replicate this eff ect on the SK PRO.
FAVORITE FORWARD/REVERSE
By selecting “Favorite Fwd, Rev,” Favorites can be
selected sequentially by using the Foot Switch to
advance either forward or backward. Also, if either
“1” or “10” are selected, the sequence will “roll over”
to the next numbered Bank (see the illustration
below).
1 2 3 4 5 6 7 8 9 10
Bank 6
Bank 7
Bank 5
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10