Motorola 68P02958C00-B - Manual (Page 153)

SNMP Configurator
5-96
•
Make sure that you have loaded the correct configuration file - the one that contains the
configuration for the IP Gateway unit you are communicating with. Use the Open
command to open a configuration file.
•
Ensure that the Toolbox computer is ready to communicate.
After you select Download, Toolbox asks you to specify the communication password, if this
is the first time that the Communication Driver is used. If the Communication Driver was
activated before, no password is required. Following the entry of the correct password, the
Download SNMP Configuration dialog is displayed.
Local
Select this parameter if the Toolbox computer is locally connected to the IP Gateway.
Remote
Select this parameter if the Toolbox computer is connected to a remote IP Gateway. This
selection enables the Site ID and Link ID parameters.
Site ID, Link ID
To configure a remote site, specify the Site ID, then open the Link ID drop-down list and
select the appropriate Link ID.
Download button
After entering the parameters, click this button to download the configuration file. Toolbox
displays the download progress, as shown below.