Motorola 68P02958C00-B - Manual (Page 212)

IP Conversion Table
5-155
Open
The Open command opens an existing IP conversion table file. When the Open command is
executed, the Toolbox displays the Open dialog box.
The Open dialog box defaults to the config sub-directory of the Toolbox directory (e.g.,
c:\itbox550\config).
Select the IP conversion table file (see parameters below) and click OK to load it.
Dialog box parameters
Use the parameters in the order specified below. Normally you’ll only use the File Name
parameter.
Save in
If the currently displayed directory is not the correct one, double-click the drive letter at the
beginning of the Directories list and locate the directory. To access sub-directories, double-
click parent directories.
File name
Type the name of the host file. Toolbox automatically adds the .ipc extension. Alternatively,
locate the file name in the file list, and double-click the name.
Save as type
This box shows the type (extension) of the files currently displayed in the File Name list. If the
displayed file type “filter” is not .ipc, open the drop-down list and select the .ipc type.
Close
The Close command closes the current IP conversion table.
Save
The Save command stores the current IP conversion table.
If the file has not been saved at least once, Toolbox opens the Save As dialog box where you
assign a name to the IP conversion file. The name may contain up to 6 characters to ensure
backward compatibility.
If the file has been saved at least once, Toolbox just saves the file.
Save As
The Save As command saves the current IP conversion table under a different file name.
Generally, you’ll use this command when you want to create an IP conversion table file that is
slightly different from an existing one (load the existing file, save it under a new name, and
make the changes).
The Save As dialog also appears when you request to save an IP conversion table file for the
first time.