Motorola 68P02958C00-B - Manual (Page 247)

Adding Terminal Server Ports
6-12
CHANGE PORT N TELNET OCRLF ENABLED
CHANGE PORT N TELNET VERBOSE DIS
CHANGE PORT N TELNET BINARY WILL BINARY DO
CHANGE PORT N TELNET ECHO WONT ECHO DONT
CHANGE PORT N TELNET SUPPRESS WILL SUPPRESS DO
INIT
At this point, the ELS16 will reboot itself. The ‘self boot’ process will take about 15 seconds.
Example: Setting 14 Ports (port 3 to 16) of ELS16 to the IP Gateway:
Terminal Server definition
Type in the following commands:
DEFINE PORT 3-16 AUTOCONNECT DIS
DEFINE PORT 3-16 ACCESS REMOTE
DEFINE PORT 3-16 CHARACTER 8
DEFINE PORT 3-16 PARITY NONE
DEFINE PORT 3-16 FLOW DIS
DEFINE PORT 3-16 BACKWARDS SWITCH NONE
DEFINE PORT 3-16 BREAK DIS
DEFINE PORT 3-16 BROADCAST DIS
DEFINE PORT 3-16 DEDICATED SERVICE NONE
DEFINE PORT 3-16 DEFAULT PROTOCOL TELNET
DEFINE PORT 3-16 DEVICE DATAONLY
DEFINE PORT 3-16 INACTIVITY LOGOUT DIS
DEFINE PORT 3-16 INTERRUPTS DIS
DEFINE PORT 3-16 SESSION LIMIT 1
DEFINE PORT 3-16 TELNET AO NONE
DEFINE PORT 3-16 TELNET AYT NONE
DEFINE PORT 3-16 TELNET BRK NONE
DEFINE PORT 3-16 TELNET EC NONE