Motorola 68P02958C00-B - Manual (Page 263)

IP Gateway Telnet Operation
6-28
Telnet Command Summary
Command Format Description
adduser <username> Adds a user to the list of valid IP Gateway users.
Enter the superuser password at the prompt.
If the password is valid, the IP Gateway prompts for the
initial password for the new user. At the prompt, confirm the
initial password for the new user. The new user name and
password are saved in the IP Gateway.
If the superuser password entered is not valid, the IP
Gateway prompts for the superuser password again.
This command can be performed by the superuser (admin)
only.
rmvuser <username> Removes a user from the list of valid IP Gateway users.
Enter the superuser password at the prompt.
If the password is valid, the user name and password are
removed from the IP Gateway.
If not, the IP Gateway prompts for the superuser password.
This command can be performed by the superuser (admin)
only.
help
help <command>
Displays the list of telnet commands.
Describes the specified command.
who Displays the list of Telnet sessions and the names of users
who are currently logged on, including the corresponding
terminal emulation (TE) connection (e.g. SC_01/Quantar0)
and TE channel ID (e.g. 1245).
***** under a TE connection signifies that the terminal
emulation is not active for this window.
(*) indicates that the current Telnet session is marked. If TE
is performed, the name of the site/device are displayed in the
TE connection column.
If the entry in the TE connection column is of the form:
/s=n1, /l=n2, /p=n3, /m=n4 | N/A, this indicates that the
connect command was activated with the ‘/s=n1, /l=n2,
/p=n3, /m=n4’ or with the ‘/s=n1, /l=n2, /p=n3’ parameters
option. This indicates that terminal emulation is performed
to a device that is connected to an Element Management Unit
(EMU) with the following specifications: