Motorola 68P02958C00-B - Manual (Page 397)

Software Diagnostics Output
C-105
13. Optional AT command string to send to modem before dialing. Used by the RTU to override default
settings in the modem. Refer to technical support if needed.
14. Radio sampling time in milliseconds that RALP will poll the radio registration status. Relevant only
if RALP is enabled.
15. Device to which the RTU is connected (iDEN,Tetra, Standard Modem, or Null Modem).
16. YES, if the RTU should disconnect Slip/PPP when getting an ICMP:Destination Unreach message.
17. YES, if the modem supports abort sequence. An abort sequence is +++ issued after a pause of 1
second and followed by another pause of 1second. If YES, the modem should switch to command
mode when this sequence is issued by the RTU. The modem may or may not disconnect from PD
channel. Tetra or Novatell (CDPD) for example do not support it, but most modems do (for example
iDEN or G18).
18. Never, if CD is being polled constantly. This includes the time while Slip/PPP is being connected and
when the connection is established. When CD drops, the modem will be disconnected by the RTU.
Always, if CD is never checked. It is assumed that it is active all the time, so its state does not denote
Slip/PPP state.
When connecting, if CD is ignored during Slip/PPP connection but polled when connection is
established.
19. Maximal Rx idle time to disconnect in seconds. If no data is received from the port for this period of
time, Slip/PPP will be disconnected. If this parameter is 0, it will never be checked.
## 2521 LEVEL = 101
IPMODM state
------------
Is modem being configured ?
: %% 1
State of configuration task : %% 2
Is CD active ? : %% 3
Has modem configuration been aborted ? : %% 4
Is Modem registered in the system ? : %% 5
Cause for configuration failure : %% 6
Last command that was sent to Modem : %% 7
Response received from modem that caused failure : %% 8
Time it took to configure modem [millisec]
: %% 9
Is port being locked ? : %%10
Last time started configure modem : %%11
Command sent to modem that caused failure : %%12
1. YES if modem is in the process of being configured. In this case, it operates in command mode, and
it cannot transmit data.
2. Connected and Registered should be displayed if the modem is online. In online mode, the modem
can transmit data.
3. YES if the CD pin is active. If YES, the modem is connected and is in online mode.
4. Internal use only.
5. YES if the packet data modem is registered in the system.