Motorola 68P02958C00-B - Manual (Page 403)

Software Diagnostics Output
C-111
Configuration Advanced Link Layer. If data was transmitted while the modem was being configured,
that data may have been lost.
5. Number of times that configuration succeeded.
6. Number of times that configuration failed. When failed, the RTU keeps reconfiguring the modem in
cycles until it succeeds. This number denote how many configuration cycles have failed.
7. Number of times the RTU failed to register the modem because it is not data packet capable. (The
modem is probably not registered in the infrastructure database.)
8. Not relevant (future use).
9. Number of times the RTU deregistered and reregistered the modem by force.
10. Number of times the RTU restarted the modem (usually because of registration problems).
11. Last event that caused the port to be failed: Modem configuration failed, or modem became
deregistered from the infrastructure.
12. Number of ICMP:Destination unreach messages received of type Network unreachable.
13. Number of times the PPP connection was dropped.
14. Number of times the Slip/PPP connection was disconnected because it failed to respond for RALP
requests. Relevant for iDEN.
15. Number of times failed to issue ATD (dialup) command to modem.
16. Number of times failed to issue ATH (disconnect) command to modem (there was no response).
17. Number of times failed to connect Slip/PPP.
Note: Activating this message with level 110 will reset these parameters.