Motorola 68P02958C00-B - Manual (Page 239)

HealthCheck Mechanism
6-4
4. Set the ‘Health-check application support’ parameter to Yes.
By default, the HealthCheck mechanism is enabled. For more details refer to the Health-check
(application) support parameter under Advanced Parameters in the Site Configuration chapter
above.
The RTU HealthCheck mechanism is activated through MOSCAD Programming ToolBox Site
Configuration utility. In order to activate it,
1. Run the Site Configuration utility from the MOSCAD Programming ToolBox.
2. Click on the Advanced tab in the workspace bar.
3. Open the Message Oriented Service advanced parameters screen.
4. Set the ‘Health-check application support’ parameter to Yes.
By default, the HealthCheck mechanism is enabled. For more details, refer to the Site
Configuration chapter in the MOSCAD Programming ToolBox manual.
HealthCheck Diagnostics
Two sets of diagnostics are relevant to the HealthCheck mechanism, the IP Gateway site table
and the HealthCheck device.
To retrieve the downloaded IP Gateway site table,
1. Run the SW Diagnostics & Loggers utility from the IP Gateway Toolbox.
2. Select device STBLA from the pull-down menu into the Device Name field in the Device
toolbar or type in STBLA. If the Device toolbar is not shown, select it from the View
menu.
3. Enter 2 in the Level field.
4. Click on the Start Communications button in the icon bar or select Start from the Loggers
menu. The site table will be displayed in the output window.
The same diagnostics can be retrieved via the Web Server (See below.)
To retrieve the current HealthCheck status of each of the links for a site,
1. Run the SW Diagnostics & Loggers utility from the IP Gateway Toolbox.
2. Select device HELTHCH from the pull-down menu into the Device Name field in the
Device toolbar or type in HELTHCH. If the Device toolbar is not shown, select it from
the View menu.
3. Enter 1 in the Level field.