Motorola 68P02958C00-B User Manual
Page 448
Error Messages
C-156
Error #876:
The TX thread did not hang up the phone line as the RX thread asked.
For system software developers. Consult product group.
Error #877:
Can not find Site Id – %% in phone book.
Can not dial a Site ID without it being defined in the phone book.
Error #878:
Modem refuses to dial this phone number (too long, invalid command, or answer
mode only):
Invalid command (internal problem).
Error #900:
PLC Switcher module, Function %%
Fatal ! The SWITCHER Device is destroyed – CRC error !
May indicate system software problem. Consult product group.
Error #901:
PLC Switcher module, Function %%
Cannot allocate a formatted buffer !
Empty heap. Consult product group.
Error #902:
PLC Switcher module, Function %%
Found in port table a logical port i.d with not expected direction
Third party protocol port definition problem.
Error #903:
PLC Switcher module, Function %%
Remove slice of formatted buffer failed !
May indicate system software problem. Consult product group.
Error #904:
PLC Switcher module, Function %%
Get slice of formatted buffer failed !
For system software developers. Consult product group.
Error #905:
PLC Switcher module, Function %%
buf_f_init of formatted buffer failed !
For system software developers. Consult product group.
Error #906:
PLC Switcher module, Function %%
Switcher format error of received frame !
May indicate system software problem. Consult product group.
Error #907:
PLC Switcher module, Function %%
Illegal direction parameter!! Getting of PLC port failed !
Third party protocol port definition error.