Motorola 68P02958C00-B - Manual (Page 415)

Software Diagnostics Output
C-123
2. Map27 mode: One of : “CONTROL", "DATA".
3. Indication that Initialization was done. (1 = yes, 0 = no)
4. Indication that this site is the initiator of the call. (1 = yes, 0 = no)
5. Indication that the IMAP27 warmup process was done (dialing). (1 = yes, 0 = no)
6. Indication that a new MAP27 (to Site ID) conversion table exists.
7. Indication that a MAP27 link to the local radio is exists.
8. Indication that the attempt to transmit a frame in MAP27 protocol has failed. (1 if failed, 0 if
succeeded)
9. Last Site ID that the RTU was talking to.
10. Last MAP27 address that the RTU was talking to.
11. Maximum size of frame transmitted in MAP27 protocol.
12. Size of last transmitted frame in MAP27 protocol.
13. Number of calls hung up by the call initiator.
14. Number of calls hung up by the call responder.
15. Total number of calls hung up.
16. Number of times needed to try to hang up.
17. Number of times tried to dial in order to initiate a call.
18. Time interval between “connected” message to the transmit begin, in order to overcome MPT1327
signaling delays.
19. Content of the last transmitted MAP27 frame.
## 2802 LEVEL = 2
Map27 address convert table:
Number of entries in table :%%1
Location of current entry
:%%2
Site ID Ident Prefix
======= ===== ======
%%3 %%3 :%%3
1. Number of entries in the conversion table.
2. Location in the memory of the conversion table.
3. The table’s actual data.