Motorola 68P02958C00-B User Manual
Page 291
APPENDIX B:
Remote ToolBox Modem Setup
B-20
Command Summary
(* indicates a change from the default)
*
B0
ITU-T answer sequence
*
E1
Enable local echo
(Must be set to E0 when modem is connected directly to the RTU as
opposed to the PC.)
L1
Low volume
M1
Speaker ON until CONNECT
*
N0
Automode is disabled. The handshake will occur based on the value of
S37.
Q0
Display result codes
T
Use tone dialing
V1
Verbal codes
W0
Report DTE speed
X4
Report all messages
Y0
Turns off long space disconnect
&C1
Normal CD operations (RLSD follows whatever the carrier is set to.)
*
&D0
DTR override
(This is necessary for the calling modem so that ESC doesn’t hang up.)
&G0
Disable guard tone
&J0
telephone jack, sets value for S21
*
&K0
Disables flow control
&Q#
not listed in help, don’t change
&R1
Ignore RTS
&S0
DSR override; always ON
&T5
Prohibits Remote Digital Loopback
&X0
Internal timing
&Y0
Resets with profile 0