Motorola 68P02958C00-B - Manual (Page 380)

Software Diagnostics Output
C-88
IPLINK LINxL
## 2200 LEVEL = 0
Iplink device key
--------------------
Heap key
: %% 1
Network key : %% 2
Network pin table : %% 3
Site ID
: %% 4
Link ID : %% 5
IP port number : %% 6
IP address : %% 7
Enable RCP : %% 8
Port is in Fail : %% 9
Group IP address : %% 10
All RTU Simulation: %% 11
Enable IPModem
: %% 12
Learn IP Address : %% 13
Check failed sites : %%14
Max echoes to send : %%15
Max sec between echoes: %%16
Max sec to check alive: %%17
When Port is defined as MDLC Over IP (Astro, iDEN,Tetra, Terminal server or Standard Modem).
1. General Heap key for transmission and reception.
2. Network layer in the unit.
3. A pointer which allows “cabling” between two devices during run time.
4. Site ID.
5. Link ID.
6. Number of the IP Port as defined in Site Configuration.
7. IP Address as defined in Site Configuration.
8. Enable RCP- Yes or No
9. Status of Link.
10. IP address used for Group Call as defined in Site Configuration.
11. YES if the Addr. range response for 'All RTU simulation' (Network Layer Advanced Parameter) was
set to non zero.
12. YES if connected to iDEN.
13. YES if the port’s IP address will be retrieved during run time, e.g. from the iDEN modem.
14. YES if the sites that are failed will be checked before transmitting to them. If the site does not reply,
transmissions will be routed to an alternative path (if such exists.) A site is considered failed when