Motorola 68P02958C00-B - Manual (Page 408)

Software Diagnostics Output
C-116
5. Signal parameter, contains the status of the system (HDLC mode).
6. Sync SYNCRONIZATION latch lock.
7. Sync SYNCRONIZATION latch data.
8. Sync holdup time. Replaces the holdup parameter in the radio model. Its purpose is to set holdup
time in the transmit mechanism.
9. Maximum time to wait until TXD_EMPTY occurs.
10. Sync RTS mode automatic "0" or on "1".
11. Sync Channel’s Delay in Msec units.
12. CONTROL RATE, MAP27 baud rate (9600 default).
13. Signal parameter, contains the status of the system (UART mode).
14. UART mode register values (later on downloaded to SCM1 (Mode register)).
15. ASYNC TX grant parameter (UART mode).
16. Number of idles to close reception.
17. Working mode of the model (SYNC_MODE="1" or ASYNC_MODE="0" ).
18. This parameter indicates if the voice channel is open or not (channel open="1" channel close="0").
19. Pointer of heap device data.
The following parameters are received from the link layer and stored here for backup; They are used in
the change mode routine.
20. MPT1327 communication device mask.
21. MPT1327 communication device system.
22. MPT 1327 communication device unit.
23. MPT 1327 communication device null.
24. MPT 1327 communication device user.
25. Maximum RX quiet time parameter.