Motorola 68P02958C00-B - Manual (Page 461)

Error Messages
C-169
Error #1504: ‘TxIntrc’ was called with invalid subgroup ‘ITxSub’ %%
This error occurs when you call the TxIntrc function with the wrong ITxSub
variable. See Intrac Protocols chapter in Advanced Features in the Application
Programmer manual.
Possible range: 0-3
Error #1505: ‘TxIntrc’ or ‘ TxWdth’ was called with invalid link ‘Tx_Lnk’ %%
This error occurs when you call the TxIntrc or TxWdth functions with the
wrong Tx_Lnk variable. See Intrac Protocols chapter in Advanced Features in
the Application Programmer manual.
Possible ranges: Radio (1)
Line (2)
LOTrnk (1)
HiTrnk (11)
Error #1506: ‘TxWdth’ was called with invalid address ‘TxTo’ %%
This error occurs when you call the TxWdth function with the wrong TxTo
variable. See Intrac Protocols chapter in Advanced Features in the Application
Programmer manual.
Possible range: 0-8191
Error #1509: Received frame with invalid length %% from INTRAC/MEIC port
In the INTRAC case, the frame length is 4 bytes. In the MEIC case the frame
length is 5-16 bytes. Any other length is invalid.
Error #1545: INTRAC modem piggyback has error %%
The error message ID (%%) may be one of the following:
ID Description
160 Piggyback got control frame from 68302 with invalid opcode
161 Piggyback got characters from 68302 not between 0A and 0D
162 Piggyback got from 68302 control frame too large
163 Piggyback got from 68302 overrun byte in rxsci
164 Piggyback got from 68302 character when cyclic buffer full
165 Piggyback tried to close frame with invalid framelength
166 Piggyback has buffer with invalid ID
167 Piggyback has buffer with invalid temporary length
168 Piggyback has pulled empty buffer which is not last in frame
169 Piggyback has watchdog reset
170 Piggyback has clock fail reset
171 Piggyback has a spike
172 Piggyback has idle line