Motorola 68P02958C00-B User Manual
Page 467
Error Messages
C-175
Error #1952:
The reception queue of the dowloaded protocol driver is full
Driver of second protocol is not emptying frames from queue fast enough.
Error #2000:
No SYNC server list was found in flash. Authentication was not activated.
An Authentication information table should be defined in the Network
Configuration tool.
Error #2001:
An invalid SYNC server list was found in flash. Authentication was not activated.
A new Authentication information table should be defined in the Network
Configuration tool.
Error #2002:
Warning: Link ID %% was denoted as an authenticated one but an error
occurred while trying to use authentication on this Link.
Authentication was not possible on the specified Link ID. Recheck the network
configuration and the port.
Error #2003:
Number of Links reported to AuthSync does not match the number of Links
known to the Network layer.
Recheck the network configuration and the ports.
Error #2004:
Warning: User has denoted to activate authentication but this could not be done
due to invalid parameters.
Be aware that Authentication is not currently active. Check Authentication
parameters in the Network Configuration tool.
Errors #3000-3999 are used for MOSCAD NFM.
Error #4030:
Invalid access code to logging flash %%.
May indicate system software error. Consult product group
Error #4031:
Logflash operation (%%) failure: %%.
Operation to the logging flash has failed. See error codes in the ‘C” Toolkit for
MOSCAD Family RTUs manual.