Motorola 68P02958C00-B - Manual (Page 400)

Software Diagnostics Output
C-108
## 2525 LEVEL = 105
LAPi related statistics in iDEN modem:
--------------------------------------
Number of PRAP message expirations
: %% 1
Number of Inbound I PDUs sent (not including retries) : %% 2
Number of Inbound All Block Retry I PDUs sent : %% 3
Number of Inbound Retry I PDUs sent : %% 4
Number of Outbound I PDUs received (not including retries) : %% 5
Number of Outbound Retry I PDUs received : %% 6
Number of PDUs lost when the LLC receives a Local Release : %% 7
Number of PDUs lost due to an error or connection loss : %% 8
Number of Inbound user bytes requested to be transmitted : %% 9
Number of Outbound user bytes received : %%10
Number of half duplex collisions detected by the LAPi LLC : %%11
Number of SABME received because of N(R) or timeout in peer : %%12
Number of unexpected UAs received
: %%13
Number of unexpected DMs received : %%14
Number of retransmissions exhausted while connect/disconnect: %%15
Number of retransmissions exhausted while transmitting I PDU: %%16
Number of N(R)s received out of valid range
: %%17
Number of N(S)s received out of valid range : %%18
Number of Retry I PDUs received without Original I PDU : %%19
Number of reliable datagrams from client too big to send : %%20
Number of unreliable datagrams from client too big to send : %%21
Number of PDUs received in a state when they were invalid : %%22
The number of invalid PDUs received from FNE : %%23
The number of multiple block I PDUs with an LLC FCS error : %%24
The parameters are obtained via RALP from modem. Only the important parameters are described
below:
2. Number of messages sent over the air towards the MDG/iDEN system. Not including the number of
retries in #3 and 4.
3,4. Number of retries for messages sent over the air towards the MDG.
5. Number of messages received from the MDG. Not including the number of retries in #6.
6. Number of retries received from the MDG.
9. Number of bytes transmitted over the air towards the MDG.
10. Number of bytes received over the air from the MDG.
All other parameters denote communication problems over the air. Contact system
administrator/technical support if not 0.
Note: After executing diagnostics, these parameters are reset in the modem.
Refer to iDEN documentation such as iDEN Protocol Manual 68P81129E10-B for an explanation of the
LAPi protocol and meaning of parameters.