Motorola 68P02958C00-B User Manual
Page 465
Error Messages
C-173
Error #1906:
Invalid conversion table in Flash
Error in MDLC over IP. IP Conversion Table which was downloaded could not
be read or is invalid. There may be a problem with the Flash or with the IP
Conversion Tool. Consult product group.
Error #1907:
IP address in conversion table for this CPU is %% instead of the configured %%
Error in MDLC over IP. Mismatch in IP Conversion Table between the IP
address of this RTU and the one configured in the table. Correct either the
table or the Site ID.
Error #1908:
Configured IP address (%%) of this CPU is in use by site %%
Error in MDLC over IP. Error in IP addresses. This error is obsolete.
Error #1909:
Failed configuring radio in encryption mode.
Error in MDLC over IP for Astro radio. Problem with radio configuration.
Relevant for encryption mode only.
Error #1910:
Failed transmission to Site %% because its IP address is myself.
RTU tried to transmit to a destination site with the same IP address as the RTU.
As a result, transmission failed. Check IP address conversion table for the
specified site; it will have the same IP address as that of the RTU. Correct IP
address.
Error #1911:
User configured RTU IP address as %% instead of modem’s configuration %%
Future use. This error will occur when connecting to a non-iDEN packet data
modem with Learn IP Address as NO. When the IP addresses configured in the
modem and RTU differ, the RTU has not learned the address from the modem.
Reconfigure RTU IP address or consult product group.
Error #1912:
Modem not configured for Packet data properly (error code %%)
Modem packet data parameters are not appropriate, e.g. no Home Agent IP
address, or no RTU IP address as expected by the infrastructure.
Error #1913:
Failed connect IPMODM to Timer key.
Internal use; should not occur. Denotes SLIP port configuration failure.
Error #1914:
Got alarm %% from iDEN modem
Got unexpected software alarm from modem (which is not software or
registration.) Denotes a problem with the modem software. Consult product
group.