Motorola 68P02958C00-B - Manual (Page 16)

1-1
Introduction
Scope of the Manual
This manual provides instructions for IP Gateway installation and operation, as well as
detailed instructions for the setup of its configuration. In addition, this manual provides the
user with an overview of the MOSCAD system including a few examples that show SCADA
control centers and NFM Manager which are integrated into the MOSCAD system via the IP
Gateway.
Additional applicable manuals are:
• MOSCAD Programming Toolbox, System Overview Manual, 68P02956C45
• MOSCAD Programming Toolbox, System Setup and Diagnostics Tools Manual,
68P02956C50
• MOSCAD Programming Toolbox, Application Programmer Manual, 68P02956C55
• MDLC Gateway for TCP/IP Application Programming Interface – User’s Manual,
68P02951C05
• MOSCAD NFM Manual, 68P02958C45
• MOSCAD RTU Service Manual, 68P02991G90
IP Gateway System and ToolBox Software Version Policy
The version numbers of the ToolBox and system software are updated according to additional
features and improvements.
Compatibility (at source level) between the ToolBox and the IP Gateway is assured only if the
version number of the ToolBox Software is later than the version number of the Gateway
system software.
A version number is composed of two numbers, as in the following example: V1.61. The one-
digit number to the left of the decimal point describes a major modification of the software,
while the two-digit number to the right of the decimal point describes a minor modification.
In this manual, some headings of major subjects are marked by the following annotation:
≥
Va.b.
For example,
≥
V1.61 indicates that the marked subject is supported by a Gateway whose
system software version number is at least 1.61.