Motorola 68P02958C00-B - Manual (Page 398)

Software Diagnostics Output
C-106
6. If last modem configuration failed, display the reason for the failure.
7. The last AT command which was sent to the modem when configuring it.
8. If modem configuration has failed, display the last response from the modem that caused this failure
(No Response if there was none).
9. Time in milliseconds that it took to configure the modem last time. Relevant only if modem
configuration has succeeded. Note that it does not denote the actual time the modem has been in
command mode, just the last cycle.
10. Should be YES when configuring the modem.
11. Marks the time that last started to configure the modem. Along with 9, this denotes the time Slip/PPP
has been reconnected.
12. The last command sent to the modem causing it to fail and issue parameter 6.
## 2522 LEVEL = 102
RALP State
----------
Diagnostic timeout
: %% 1
IP Port Number : %% 2
IP Address : %% 3
Was RALP initiated : %% 4
Is Communication Enabled in Radio : %% 5
Is request being executed
: %% 6
Current exectued group : %% 7
Current executed opcode : %% 8
Current expected opcode : %% 9
Pointer of response buffer : %% 10
Relevant for iDEN only.
1. Time in milliseconds to wait for a response from the iDEN modem to a RALP command. Refer to
Modem diagnose reply timeout parameter in the Site Configuration Advanced Link Layer.
2. IP port number of the RALP protocol.
3. IP Address of the modem for the RALP protocol.
4. YES if a RALP session has been initiated with the modem.
5. YES if the modem has enabled RALP communication with the RTU.
6. YES if the RTU expects a RALP response from the modem.
7. Currently executed RALP command group
8. Currently executed RALP opcode.
9. Currently executed RALP opcode.
10. Internal use only.