7 phy management interface (pmi), Phy management interface data register (pmi_data), Phy management interface data register – SMSC LAN9312 User Manual
Page 243: Pmi_data), Access only), Section 14.2.7.1, Datasheet 14.2.7 phy management interface (pmi)
High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9312
243
Revision 1.4 (08-19-08)
DATASHEET
14.2.7
PHY Management Interface (PMI)
The PMI registers are used (by the EEPROM Loader only) to indirectly access the PHY registers.
Refer to
Section 14.4, "Ethernet PHY Control and Status Registers," on page 285
for additional
information on the PHY registers.
Note:
These registers are only accessible by the EEPROM Loader and NOT by the Host bus. Refer
to
Section 10.2.4, "EEPROM Loader," on page 149
for additional information.
14.2.7.1
PHY Management Interface Data Register (PMI_DATA)
This register is used in conjunction with the
PHY Management Interface Access Register
to perform write operations to the PHYs.
Note:
This register is only accessible by the EEPROM Loader and NOT by the Host bus. Refer to
Section 10.2.4, "EEPROM Loader," on page 149
for additional information.
Offset:
0A4h
EEPROM Loader
Access Only
Size:
32 bits
BITS
DESCRIPTION
TYPE
DEFAULT
31:16
RESERVED
RO
-
15:0
MII Data
This field contains the value written to the PHYs. For a write operation, this
register should be first written with the desired data.
WO
00000000h