SMSC LAN9312 - Manual (Page 28)

High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Datasheet
Revision 1.4 (08-19-08) 28 SMSC LAN9312
DATASHEET
3.2 Pin Descriptions
This section contains the descriptions of the LAN9312 pins. The pin descriptions have been broken
into functional groups as follows:
„ LAN Port 1 Pins
„ LAN Port 2 Pins
„ LAN Port 1 & 2 Power and Common Pins
„ Host Bus Interface Pins
„ EEPROM Pins
„ Dedicated Configuration Strap Pins
„ Miscellaneous Pins
„ PLL Pins
„ Core and I/O Power and Ground Pins
„ No-Connect Pins
Note: A list of buffer type definitions is provided in Section 1.2, "Buffer Types," on page 18 .
Table 3.1 LAN Port 1 Pins
PIN NAME SYMBOL
BUFFER
TYPE DESCRIPTION
89-92
Port 1 LED
Indicators
nP1LED[3:0] OD12 LED Indicators: When configured as LED outputs
via the
LED Configuration Register (LED_CFG) ,
these pins are open-drain, active low outputs and
the pull-ups and input buffers are disabled. The
functionality of each pin is determined via the
LED_CFG[9:8] bits.
General
Purpose I/O
Data
GPIO[3:0] IS/O12/
OD12
(PU)
General Purpose I/O Data: When configured as
GPIO via the
LED Configuration Register
(LED_CFG) , these general purpose signals are
fully programmable as either push-pull outputs,
open-drain outputs or Schmitt-triggered inputs by
writing the
General Purpose I/O Configuration
Register (GPIO_CFG) and General Purpose I/O
Data & Direction Register (GPIO_DATA_DIR) . The
pull-ups are enabled in GPIO mode. The input
buffers are disabled when set as an output.
Note: See Chapter 13, "GPIO/LED Controller,"
on page 162 for additional details.
110
Port 1
Ethernet TX
Negative
TXN1 AIO Ethernet TX Negative: Negative output of Port 1
Ethernet transmitter. See
Note 3.1 for additional
information.
111
Port 1
Ethernet TX
Positive
TXP1 AIO Ethernet TX Positive: Positive output of Port 1
Ethernet transmitter. See
Note 3.1 for additional
information.
115
Port 1
Ethernet RX
Negative
RXN1 AIO Ethernet RX Negative: Negative input of Port 1
Ethernet receiver. See
Note 3.1 for additional
information.
116
Port 1
Ethernet RX
Positive
RXP1 AIO Ethernet RX Positive: Positive input of Port 1
Ethernet receiver. See
Note 3.1 for additional
information.