Nortel Networks NN43001-106 - Manual (Page 350)

350 Attendant Supervisory Console
Operating parameters
The supervisory console and all attendant consoles (except M2250
attendant consoles) in the customer group must be assigned to QPC297
Attendant Console Monitor circuit packs. Their prime TN must be assigned
to unit 0 and the secondary TN must be assigned to unit 1. Units 2 and 3
can be used for power; otherwise they must be left unassigned.
ATTENTION
M2250 attendant consoles must be a minimum vintage of AD and have the
Attendant Supervisory Module (ASM) installed to allow supervision.
The supervisory console must have a Digit Display (DDS).
An M2250 console equipped with a Busy Lamp Field/Console Graphics
Module (BLF/CGM) can display the status of all attendant consoles (up to
the maximum 63) by using the Enhanced Busy Lamp Field mode. The
BLF/CGM must be minimum vintage AD to provide this capability.
One supervisory console can be assigned per customer. Only one attendant
console (1 to 63) can be assigned as a supervisory console.
The customer group must be equipped with more than one attendant.
When using the Attendant Supervisory Module (ASM), the console TN must
be configured on unit 0, 4, 8, 16, and so on. The secondary TN (SETN) unit
must succeed the Primary TN (1, 5, 9, 17, and so on). The ASM TN is then
configured with TYPE = PWR. The PWR TN must succeed the SETN (2,
6, 10, 18, and so on).
Feature interactions
Add-on modules
Add-on modules (key/lamp strips and lamp field arrays used to display
attendant status) can be used for other purposes defined by the customer
when the console is in Normal mode; however if the Busy Lamp Field is
assigned to display attendant status, it cannot be used for other functions
during any mode of the attendant console.
Attendant Administration
Attendant Administration mode can be entered directly from the supervisory
console from Supervisory or Normal mode by pressing the program (PRG)
key. The Supervisory mode does not need to be terminated first.
Attendant Position Busy
Activation of the Position Busy key on a Supervisory console puts the
console in the supervisory mode.
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106 01.04 Standard
Release 5.0 27 July 2007
Copyright © 2007, Nortel Networks
.