Nortel Networks NN43001-106 - Manual (Page 562)

562 Busy Tone Detection for Asia Pacific and CALA
Feature interactions
European XFCOT Support
When the XFCOT Busy Tone ID (BTID) is configured in Overlay 14 only the
BTID is downloaded to the XFCOT card. The BTID is downloaded to the
EXUT card when the Busy Tone Detection (BTD) package 294 is equipped.
Trunk to Trunk Connection
When the Trunk to Trunk Connection feature interacts with Busy Tone
Detection for Asia Pacific and CALA, which ever feature occurs first takes
precedence.
Timed Forced Disconnect
When Timed Forced Disconnect interacts with Busy Tone Detection for Asia
Pacific and CALA, whichever feature occurs first takes precedence.
Feature packaging
Busy Tone Detection for Asia Pacific and CALA requires Busy Tone
Detection (BTD) package 294.
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1. LD 97 – Configure Busy Tone Detection (BTD) table parameters.
2. LD 16 – Configure trunk units and trunk timers in the Route Data Block.
3. LD 14 – Configure Busy Tone Supervision for a new Central Office Trunk.
Once the BTD table is configured, the new trunks can be entered and the
required BTD table is assigned on a card basis. The BTD table number can
only be entered in for the first unit programmed on the card.
LD 97 - Configure Busy Tone Detection (BTD) table parameters.
Prompt Response Description
REQ CHG Change existing data.
TYPE BTD Busy Tone Detection.
BTDT (0) - 7 Busy Tone Detection Table.
BCAD
(350) (350)
Busy Tone Cadence (in milliseconds).
(ON cycle) (OFF cycle) (default)
500 500 For Japan.
The values for each cycle are 0 to 1.5 seconds (1500 ms)
and are entered in milliseconds. Input values are rounded to
the nearest multiple of 25 ms. If zero (0) is entered for both
phases, then a continuous tone occurs.
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106 01.04 Standard
Release 5.0 27 July 2007
Copyright © 2007, Nortel Networks
.