GE Industrial Solutions ASTAT BP - Manual (Page 22)

ASTAT BP User Manual
22 GE Industrial Solutions ©2013 GE Company All Rights Reserved
4.5.5 Calibrate Voltage and Current (Factory Use Only!)
Press the Mode and ▼ keys simultaneously. The LCD will display:
Test/Maintenance
Statistics
Press the Select key five times. The LCD will display:
Calibration VOLT
0 VOLT
Press the Select key. The LCD will display:
Calibration CURR
5% of Ir
Press the Select key. The LCD will display:
POWER FACTOR
0.71
Press the Mode and
▼ keys simultaneously to exit the Test/Maintenance mode.
44..66 Mode Pages
Upon initiation of the ASTAT-BP, the LCD displays motor’s operating current:
Motor Current
I<0.1 Ir
You can review all mode pages by pressing the Mode key:
Main Settings
- **** -
Start Settings
- **** -
Stop Settings
- **** -
DUAL Settings
Parameters
These pages are skipped if ASTAT-BP is programmed to Minimized
Mode and are shown only in Maximized Mode. Refer to section 4.7.2
on page 26 for changing display mode from MINIMIZED MODE to
MAXIMIZED MODE.
Slow SP & Saving
Parameters
Fault Settings
- **** -
I/O Settings
Parameters
COMM. Parameters
- **** -
Statistical Data
- **** -