GE Industrial Solutions ASTAT BP - Manual (Page 43)

ASTAT BP User Manual
43 GE Industrial Solutions ©2013 GE Company All Rights Reserved
Function &
Default
Range Unit Description
Parity Check
AUTO (DeviceNet)
User can not change Parity Check value.
DeviceNet ID
Set Manually
Set the unit ID by changing the position of the rotary
switches on the optional PCB as shown on section C.1.5
page 103.
S. Link Par. Set
Disabled
Enabled/
Disabled
Enables parameter modification via serial
communication
Ser. Link Control
Disabled
Enabled/
Disabled
Enables start, stop, reset etc. via serial communication
TIME OUT
Auto (Profibus)
Auto Do not change this parameter! Must be set to Auto
Store Settings
COMM. Parameters
Enabled/
Disabled
Same as Store Settings Main Settings on
page 28.
Note:
After changing communication parameters and storing
them, control power must be switched OFF and ON to
load new communication parameters.