Cub Cadet I-Beam Style - Manual (Page 103)

3-84
NOTE
Place the block of wood directly over the end
of the input shaft and tap down on the assem-
bly.
5.Remove the large thrust washer and the wide
30T forward tine idler gear assembly from the
jack shaft. See Figure 3-247.
6.Remove the large thrust washer and 30T spur
gear on the center jack shaft assembly.
7. Grasp the 18T tine shaft assembly and the 9T
tine input sprocket assembly and raise both
until the 9T tine input sprocket assembly
comes free of the center jack shaft assembly.
See Figure 3-248.
8.Pivot the 9T tine input sprocket assembly and
#50 chain away from the center jack shaft
assembly. See Figure 3-249.
9.Remove the upper 44T spur gear from the cen-
ter jack shaft assembly.
10.Remove the large flat washer, 44T lower spur
gear, and 11T inner gear assembly from the
center jack shaft assembly. See Figure 3-250.
Tillers.fm Page 84 Tuesday, February 19, 2002 1:28 PM