Cub Cadet I-Beam Style - Manual (Page 72)

3-53
3
14.Remove shifting bracket and spacer. See Fig-
ure 3-144.
NOTE
In 1989 and earlier production the shift bracket
could slide out. In 1990 and later production
there is a snap ring on the shifting bracket on
the outer side of the housing to help absorb
shock during shipping. This will help avoid
damage to the shifting bracket that would
cause loss of shifting capability.
15.Remove the 30 tooth spur. Clean and inspect
for damage. Replace if necessary. See Figure
3-145.
NOTE
Hub side of spur gear goes up upon reassem-
bly.
16.Remove flat washer, spacer, three flat washers
and three jackshafts from housing. See Figure
3-146.
17.To reassemble chain case, reverse preceding
steps.
Tillers.fm Page 53 Tuesday, February 19, 2002 1:28 PM