Cub Cadet I-Beam Style - Manual (Page 245)

6-46
3. Remove the plastic protective cap from the fit-
ting on top of the filter head housing.
4. Attach the free end of the return hose to the fil-
ter head housing inlet. See Figure 6-39.
5. Lower the hose clamp until it is 1/2" away from
the end of the return tube at the filter head
housing, and secure it in place using a 5/16"
socket. See Figure 6-40.
Pressure Hose Installation
1. Place the beam assembly in the horizontal
position. See Figure 6-41.
2. Route the free end of the pressure hose
(removed previously) between the beam and
the tongue tube.
3. Secure the high pressure hydraulic hose to the
45 degree hydraulic pump adapter (below the
engine) using two 7/8" wrenches. See Figure
6-42.
Figure 6-38.
Figure 6-39.
Figure 6-40.
Figure 6-41.
Log Splitters 2.fm Page 46 Wednesday, February 20, 2002 1:35 PM