Cub Cadet I-Beam Style - Manual (Page 175)

5-36
6. To separate auger housing from frame assem-
bly, two people are required. One person is in
the operating position. Squeeze auger clutch
grip (right hand) as you raise up on handles.
The other person is in front of the unit. Push
down on housing or optional drift cutters. The
unit will separate into two pieces. See Figure
5-60.
5-6.6 Auger Belt Removal. To remove auger belt,
proceed as follows:
1. Remove hex screw and belleville washer from
the center of pulley on auger housing. Remove
pulley. Be careful not to lose key. See Figure 5-
61.
2. Remove auger drive belt.
NOTE
If drive belt needs to be replaced, skip to para-
graph 5-6.7 before proceeding to step 3.
3. Reassemble pulley to auger housing with hex
screw and belleville washer (cupped side is
toward the pulley). Be certain key is in place on
shaft.
4. Reassemble the two halves of unit. Two people
are required.
NOTE
If the two halves do not reassemble easily,
idler pulley and/or brake shoe may be behind
large pulley.
5. Secure the two halves with two screws and
lock washers.
6. Slip auger drive belt over engine pulley.
7. Reassemble large shoulder bolt, spacer and
belleville washer as shown. Belleville washer
goes on shoulder bolt between idler bracket
assembly and engine plate (cupped side
toward engine plate).
SNOW THROWER.fm Page 36 Wednesday, February 20, 2002 10:28 AM