Cub Cadet I-Beam Style - Manual (Page 183)

5-44
2. Remove plastic belt cover on the front of
engine by removing two self-tapping screws.
See Figure 5-76.
3. Unthread the bottom of auger cable from the
top of cable leaving hex nut in place.
4. Remove six hex bolts, lock washers and hex
nuts which attach auger housing assembly to
the frame. See Figure 5-77.
5. Separate housing from frame assembly by
standing in the operating position and lifting up
on the handles. The frame and housing will
separate and rear auger drive belt will come off
the pulleys. See Figure 5-78.
6. To remove front auger drive belt, push idler
pulley to the left and lift front auger drive belt
from front auger pulley. See Figure 5-79.
7. Replace both auger drive belts by following
instructions in reverse order.
8. When reassembling the two halves of the unit,
auger drive cable must be routed through
cable roller guides. See Figure 5-80.
SNOW THROWER.fm Page 44 Wednesday, February 20, 2002 10:28 AM