Cub Cadet I-Beam Style - Manual (Page 163)

5-24
6. To remove auger drive belt, remove four shoul-
der bolts and belleville washers at auger pul-
ley. A 3/4 inch wrench is required. See Figure
5-32.
7. Remove and replace auger belt.
8. To remove drive belt, disconnect extension
spring at engine plate.
9. Remove drive belt from engine pulley and bot-
tom of drive pulley. See Figure 5-33.
10. Replace belt and reassemble in reverse order.
11. Reassemble two snow thrower halves.
NOTE
Be sure auger arm assembly pin is into slot of
auger clutch bracket before inserting top bolts
into auger housing and frame. See Figure 5-
34.
SNOW THROWER.fm Page 24 Wednesday, February 20, 2002 10:28 AM