Cub Cadet I-Beam Style - Manual (Page 44)

3-26
5.Slip engine pulley out until belt can be
removed.
6.Install new belt.
3-6.3 Removal and Replacement of Short Drive
Belt.
1.Remove tine belt as instructed in previous
paragraph.
2.Remove hex bolt, lock washer and flat washer
from rear engine pulley. Slip rear engine pulley
off engine.
3.Loosen two set screws on front engine pulley.
See Figure 3-54.
NOTE
Do not lose square key on engine shaft.
4.Remove lock nut on V-idler pulley.
5.Slide front engine pulley and V-idler pulley out.
See Figure 3-55.
6.Remove belt and install new belt. Be sure belt
is routed around guide pins. See Figure 3-56.
NOTE
Belt must be between V-idler pulley and idler
bracket.
Tillers.fm Page 26 Tuesday, February 19, 2002 1:28 PM