Cub Cadet I-Beam Style - Manual (Page 8)

1-7
1
4. Roll the belt off of the crankshaft pulley, and
slip the belt between the pulley and the rear
axle. See Figure 1-21.
Figure 1-21.
5. Remove the belt from the spindle pulley.
6. Follow hte instructions in the reverse order to
install the belt.
NOTE
The belt has been updated from part number
754-0489 to part number 754-0625. The new
belt is more resistant to stretching.
NOTE
The control cable is secured to the axle, make
certain it is clear of rotating parts.
WHEELS AND AXLE
Each wheel can be removed by taking off a
single bolt and washer, using a 7/16" wrench.
See Figure 1-22.
Figure 1-22.
There is a stop welded to the axle where it
passes through the right hand side of the trim-
mer base. This stop will not allow the axle to
slide or rotate. See Figure 1-23.
Figure 1-23.
There is a removable spacer and wave
washer between the left hand side wheel and
the trimmer base. See Figure 1-24.
Figure 1-24.
To remove the axle;
1. Remove the left hand side wheel bolt.
2. Slide the axle and wheel to the right, as
described in the belt removal section.
OTHER FEATURES
The control handle on the 22" model is
equipped with a safety lock-out. See Figure 1-
25.
01 String Trimmers.fm Page 7 Tuesday, February 19, 2002 1:05 PM