Cub Cadet I-Beam Style - Manual (Page 7)

1-6
1. Secure the pulley flywheel so that it will not
spin during removal of the crankshaft bolt.
See Figure 1-17.
Figure 1-17.
2. Remove the crankshaft bolt using a 5/8"
wrench.
3. Remove the bolt from the left side of the axle
using a 7/16" wrench.
4. Remove the left wheel and slide the right
wheel and axle out of the trimmer frame. See
Figure 1-18.
Figure 1-18.
5. Roll the belt off of the pulley flywheel.
6. Slip the pulley flywheel off of the engine crank
shaft.
7. Remove the belt.
Follow the instructions in the reverse order to
install the belt.
TRIMMERS WITH STANDARD CRANkSHAFT
PULLEYS
NOTE
For trimmers equipped with standard crank-
shaft pulleys, follow steps 1 through 10, then
complete these steps;
1. Loosen, but do not remove the remaining nuts
that fasten the spindle and belt tensioner
bracket to the trimmer base using a 1/2"
wrench. See Figure 1-19.
Figure 1-19.
2. Loosen, but do not remove the center bolt that
fastens the spindle to the trimmer frame using
a 1/2" wrench.
3. Loosen, but do not remove the three bolts that hold
the engine and engine pulley belt keeper to the
trimmer frame, using a 1/2" wrench. See Figure 1-
20.
Figure 1-20.
01 String Trimmers.fm Page 6 Tuesday, February 19, 2002 1:05 PM