Cub Cadet I-Beam Style User Manual
Page 51
Advertising
3-32
3.To remove reverse drive belt, lift up on small
idler pulley. Slip belt off outside sheave of
wheel chain case pulley. Remove belt from
two-step engine pulley. See Figure 3-73.
4.Loosen (do not remove) hex nut at the top of
wire belt keeper. See Figure 3-74.
5.Pull bottom of wire belt keeper out and then
upward, pivoting it away from the forward
engine pulley.
6.Lift forward drive belt off forward engine pulley
and remove. See Figure 3-75.
NOTE
When reassembling belts, be certain belts are
routed around all belt keeper pins.
7.Reassemble new belts, following instructions
in reverse order. See Figure 3-76.
Tillers.fm Page 32 Tuesday, February 19, 2002 1:28 PM
Advertising