Cub Cadet I-Beam Style - Manual (Page 57)

3-38
5.Remove bolts and nuts securing the LH and
RH tine shield brackets, located on inside front
of the tine shield. Remove the nuts and bolts
on top rear of chain case. Separate rear
assembly from case. Remove the tines. See
Figure 3-86.
NOTE
During assembly, loosely replace all nuts and
bolts to ensure proper fit. With all fasteners in
place, tighten securely.
6.Remove the bolts and nuts at the front of the
gear case (two at top and three at front and
two on bottom). Separate case from frame.
See Figure 3-87.
NOTE
It is not necessary to remove the engine from
the frame to change a gear case.
7.Roll the case assembly back away from the
frame. Remove the reinforcement plate and
idler bracket, the shift bracket, tines and
wheels from the gear case. See Figure 3-88.
After chain case repairs are completed or a
replacement case is procured, reassemble in
reverse order of steps above.
When installing the shift bracket, do not force
the bracket onto the shaft.
3-8.7 Disassembly and Reassembly.
1.Lay the transmission on its right side. Provide
support as needed. See Figure 3-89.
Tillers.fm Page 38 Tuesday, February 19, 2002 1:28 PM