Cub Cadet I-Beam Style User Manual
Page 165
5-26
5-4.6
Track Adjustment.
WARNING
Disconnect spark plug wire from spark plug
and ground against engine. Drain fuel from fuel
tank.
CAUTION
The tension on the tracks of the snow thrower
can be adjusted. There are track adjusters on
each side of both tracks. It is important that
each track is adjusted equally on both sides.
1.
Tip snow thrower forward so that it rests on
housing or optional drift cutters and skid
shoes.
2.
Loosen hex bolt on track adjuster.
NOTE
The track is properly adjusted when there is
approximately 1/2 inch deflection in the track
(track can be raised 1/2 inch).
3.
Insert a screwdriver between tab on adjuster
and heavy washer and pivot track adjuster to
tighten or loosen track.
4.
Tighten hex bolts.
5-4.7
Track Lock Lever Adjustment.
See Figure 5-
39.
SNOW THROWER.fm Page 26 Wednesday, February 20, 2002 10:28 AM