Cub Cadet I-Beam Style - Manual (Page 169)

5-30
5-5.5 Auger Belt Removal and Replacement.
1. Remove chute crank at chute assembly by
removing cotter pin and flat washer.
2. Remove side and rear belt covers from right
hand side of auger housing as follows:
a. Model 345: Remove hex nut and belleville
washer from front of skid shoe. Remove
two self-tapping screws. See Figure 5-43.
b. Models 355 and 385: Remove upper hex
nut and lock washer on drift cutter on the
right side of the unit. Remove hex nut and
belleville washer from the front of skid
shoe. Remove two truss machine screws
on top of the unit. See Figure 4-44.
NOTE
Upon reassembly, make certain spacers are
on the carriage bolts inside the side cover.
c. All models: Remove belt cover on the back
of auger housing by removing two self-tap-
ping screws on Model 345. On Models 335
and 385, remove one self-tapping screw.
Lift off belt covers. See Figure 5-45.
3. Remove top plastic belt cover by removing four
self-tapping screws and flat washers. See Fig-
ure 5-46.
4. Remove top bolts which attach auger housing
to frame assembly. A 9/16 inch wrench is
required. See Figure 5-47.
SNOW THROWER.fm Page 30 Wednesday, February 20, 2002 10:28 AM