Cub Cadet I-Beam Style User Manual
Page 176
5-37
5
NOTE
Shoulder of the bolt must go through both
sides of idler bracket assembly.
8.
Reassemble belt cover and chute crank.
5-6.7
Drive Belt Removal. To remove drive belt,
proceed as follows:
1.
Remove cotter pin which holds linkage rod to
idler bracket assembly.
2.
Unhook extension spring from engine plate.
See Figure 5-62.
3.
Remove drive belt from engine pulley and bot-
tom drive pulley.
4.
Replace belt and reassemble in reverse order.
5-7.
33-INCH SNOW THROWER MODEL 960
(See Figure 5-63).
5-7.1
Model Specifications. For a summary of
specifications, see Table 5-3.
5-7.2
Drive clutch adjustment. Refer to Models 840
and 850 in paragraph 5-6.1.
5-7.3
Auger clutch adjustment. Refer to Models 840
and 850 in paragraph 5-6.1.
5-7.4
Shift rod adjustment. Refer to Models 840 and
850 in paragraph 5-6.3.
5-7.5
Changing the friction wheel. Refer to Models
840 and 850 in paragraph 5-6.4. See Figure 5-
55.
SNOW THROWER.fm Page 37 Wednesday, February 20, 2002 10:28 AM