Cub Cadet I-Beam Style - Manual (Page 209)

6-13
6
6-3.3 Belt Removal or Replacement.
WARNING
Disconnect spark plug wire from spark plug
and ground it against engine block.
1. Drain gasoline from fuel tank or place a piece
of plastic under cap to prevent leakage.
2. Tip splitter on one side.
3. Remove four self-tapping screws from bottom
belt cover and frame. See Figure 6-11.
4. Using a 9/16 inch wrench, remove engine pul-
ley by removing hex bolt and lock washer. Slip
pulley and belt off. Be careful not to lose
square key on crankshaft. See Figure 6-12.
5. Loosen three engine mounting bolts using a
1/2 inch wrench. See Figure 6-13.
6. Install new belt.
7. Slide engine outward to tighten new belt until
there is approximately 1/2 inch deflection.
Tighten engine mounting bolts securely.
6-3.4 Belt Adjustment.
WARNING
Disconnect spark plug wire from spark plug
and ground it against engine.
1. Drain gasoline from fuel tank or place a piece
of plastic under cap to prevent leakage.
2. Tip splitter on one side.
3. Remove four self-tapping screws from bottom
belt cover and frame.
4. Loosen three engine mounting bolts using a
1/2 inch wrench.
5. Slide engine outward to tighten belt until there
is approximately 1/2 inch deflection. Tighten
engine mounting bolts securely.
6-4. LOG SPLITTERS MODELS 642 AND 645
(See Figures 6-14 and 6-15).
Log Splitters 2.fm Page 13 Wednesday, February 20, 2002 1:35 PM