Cub Cadet I-Beam Style - Manual (Page 66)

3-47
3
8.Remove belt cover from left side of tiller as fol-
lows. See Figure 3-120.
a.Remove two self-tapping screws and flat
washers from the top of belt cover.
b.Remove hex nut and flat washer from hex
bolt which goes through the frame and
middle of the belt cover (head of bolt is
inside the frame rail on the other side of
the tiller). Two 9/16 inch wrenches are
required.
c.Remove hex nut and flat washer from weld
bolt at the bottom of the front of the belt
cover.
9.Remove hex lock nut from weld bolt on idler
bracket and unhook spring. See Figure 3-121.
10.Loosen bottom hex nut on drive cable and
remove drive cable from cable bracket. See
Figure 3-122.
11.Remove throttle control cable from the engine
by removing self-tapping screw and casing
clamp. Unhook Z end of cable. See Figure 3-
123.
Tillers.fm Page 47 Tuesday, February 19, 2002 1:28 PM